Description Of Parameter Settings - Delta Electronics AC Motor Drive VFD-G User Manual

4.3 Description of Parameter Settings

Group 0: User Parameters
00 - 00 Software Version
This parameter displays the software version of AC drive.
00 - 01 AC Drive Status Indication 1
This parameter displays the AC drive status.
Code AC Drive Status
00 No fault occurred
01 oc
02 ov
03 oH
04 oL
05 oL1
06 EF (external fault)
07 occ (AC drive IGBT fault )
08 CF3 (CPU failure)
09 HPF (hardware protection
failure)
10 ocA (over current during
acceleration)
11 ocd (over current during
deceleration)
12 Ocn (over current during
steady state)
13 GFF (ground fault)
14 Lv (under voltage)
15 CF1
16 CF2
17 bb (base block)
18 oL2 (over load 2)
19 Reserved
20 codE
21 EF1 (external emergency
stop)
Revision July 2008, EG03, SW V1.06
: This parameter can be set during operation.
over current
over voltage
over temperature
overload
electronic thermal relay
EF-DCM is closed
IGBT short circuit protection
Abnormal A/D reading during self-check
Hardware protection function activated during self-check.
Output current exceeds protection level during
acceleration
Output current exceeds protection level during
deceleration
Output current exceeds protection level during steady
state operation.
Ground fault protection feature activated
Low input voltage
EEPROM input data is abnormal
EEPROM output data is abnormal
BB is set and activated
Output current exceeds rated motor current
software or password protection
EF1 (a multifunction-DCM is enabled)
Chapter 4 Parameters|
Factory setting: Read Only
Factory setting: Read Only
Explanation
4-23