Delta Electronics AC Motor Drive VFD-G User Manual page 101

Chapter 4 Parameters|
05 - 17 Time Duration of 1st Step Speed
05 - 18 Time Duration of 2nd Step Speed
05 - 19 Time Duration of 3rd Step Speed
05 - 10 Time Duration of 4th Step Speed
05 - 21 Time Duration of 5th Step Speed
05 - 22 Time Duration of 6th Step Speed
05 - 23 Time Duration of 7th Step Speed
05 - 24 Time Duration of 8th Step Speed
05 - 25 Time Duration of 9th Step Speed
05 - 26 Time Duration of 10th Step Speed
05 - 27 Time Duration of 11th Step Speed
05 - 28 Time Duration of 12th Step Speed
05 - 29 Time Duration of 13th Step Speed
05 - 30 Time Duration of 14th Step Speed
05 - 31 Time Duration of 15th Step Speed
Settings
Pr.05-17 to Pr.05-31 correspond to operation time of each step speed defined by Pr.05-00 to
Pr.05-14. The maximum setting 65500 seconds will be displayed as t6550. If it is displayed
t6550. that means 6550 seconds.
Note: If a parameter is set to "00" (0 sec), the corresponding step will be skipped. This is commonly
used to reduce the number of program steps.
4-50
0.0~65500 Sec / 0.0~6550.0 Sec
Unit: 1 /0.1sec
Unit: 1 /0.1sec
Unit: 1 /0.1sec
Unit: 1 /0.1sec
Unit: 1 /0.1sec
Unit: 1 /0.1sec
Unit: 1 /0.1sec
Unit: 1 /0.1sec
Unit: 1 /0.1sec
Unit: 1 /0.1sec
Unit: 1 /0.1sec
Unit: 1 /0.1sec
Unit: 1 /0.1sec
Unit: 1 /0.1sec
Unit: 1 /0.1sec
Factory Setting: 0.0
Revision July 2008, EG03, SW V1.06