Plc Mode - Delta Electronics AC Motor Drive VFD-G User Manual

Chapter 4 Parameters|
Group 5: Multi-step Speed Parameters
05 - 00 1st Step Speed Frequency
05 - 01 2nd Step Speed Frequency
05 - 02 3rd Step Speed Frequency
05 - 03 4th Step Speed Frequency
05 - 04 5th Step Speed Frequency
05 - 05 6th Step Speed Frequency
05 - 06 7th Step Speed Frequency
05 - 07 8th Step Speed Frequency
05 - 08 9th Step Speed Frequency
05 - 09 10th Step Speed Frequency
05 - 10 11th Step Speed Frequency
05 - 11 12th Step Speed Frequency
05 - 12 13th Step Speed Frequency
05 - 13 14th Step Speed Frequency
05 - 14 15th Step Speed Frequency
Settings
The Multi-Function Input Terminals (refer to Pr.04-00 to 04-03) are used to select one of the
AC drive Multi-Step speeds. The speeds (frequencies) are determined by Pr.05-00 to 05-14
shown above.
05 - 15

PLC Mode

Settings
This parameter selects the mode of PLC operation for the AC drive. The AC drive will change
speeds and directions according to the user's desired programming.
4-46
0.00~160.00 Hz
00 Disable PLC operation
01 Execute one program cycle only
02 Continuously execute program cycles
03 Execute one program cycle only and step by step
04 Continuously execute program cycles step by step
Factory Setting: 0.00
Factory Setting: 00
Revision July 2008, EG03, SW V1.06
Unit: 0.01
Unit: 0.01
Unit: 0.01
Unit: 0.01
Unit: 0.01
Unit: 0.01
Unit: 0.01
Unit: 0.01
Unit: 0.01
Unit: 0.01
Unit: 0.01
Unit: 0.01
Unit: 0.01
Unit: 0.01
Unit: 0.01