Start-Up Display Selection; Content Of Multi-Function Display - Delta Electronics AC Motor Drive VFD-EL User Manual

This parameter allows the user to reset all parameters to the factory settings except the fault
records (Pr.06.08 ~ Pr.06.12).
50Hz: Pr.01.00 and Pr.01.01 are set to 50Hz and Pr.01.02 will be set by Pr.00.12.
60Hz: Pr.01.00 and Pr.01.01 are set to 60Hz and Pr.01.02 is set to 115V, 230V or 460V.
When Pr.00.02=1, all parameters are read-only. To write all parameters, set Pr.00.02=0.

Start-up Display Selection

00.03
Settings 0
1
2
3
4
This parameter determines the start-up display page after power is applied to the drive.
00.04

Content of Multi-function Display

Settings 0
1
2
3
4
5
6
7
8
Revision August 2008, 2ELE, V1.02
Display the frequency command value (Fxxx)
Display the actual output frequency (Hxxx)
Display the output current in A supplied to the motor
(Axxx)
Display the content of user-defined unit (Uxxx)
FWD/REV command
Display the content of user-defined unit (Uxxx)
Display the counter value which counts the number of
pulses on TRG terminal
Display status of multi-input terminals (d)
Display the actual DC BUS voltage in VDC of the AC
motor drive
Display the output voltage in VAC of terminals U/T1,
V/T2, W/T3 to the motor.
Display PID analog feedback signal value in %
Display the power factor angle in º of terminals U/T1,
V/T2, W/T3 to the motor
Display the output power in kW of terminals U, V and W
to the motor.
Display PID setting and feedback signal.
Chapter 4 Parameters|
Factory Setting: 0
Factory Setting: 0
4-27