Delta Electronics AC Motor Drive VFD-EL User Manual page 51

Chapter 4 Parameters|
Parameter Explanation
03.01 Reserved
03.02 Desired Frequency
Attained
Analog Output
03.03
Signal Selection
(AFM)
03.04 Analog Output Gain
03.05 Terminal Count
Value
Preliminary Count
03.06
Value
EF Active When
03.07 Terminal Count
Value Attained
03.08 Fan Control
03.09 Reserved
4-8
Settings
11: Preliminary count value attained
12: Over Voltage Stall supervision
13: Over Current Stall supervision
14: Heat sink overheat warning
15: Over Voltage supervision
16: PID supervision
17: Forward command
18: Reverse command
19: Zero speed output signal
20: Warning(FbE,Cexx, AoL2, AUE, SAvE)
21: Brake control (Desired frequency
attained)
22: AC motor drive ready
0.00 to 600.0Hz
0: Analog frequency meter
1: Analog current meter
1 to 200%
0 to 9999
0 to 9999
0: Terminal count value attained, no EF
display
1: Terminal count value attained, EF active
0: Fan always ON
1: 1 minute after AC motor drive stops, fan
will be OFF
2: Fan ON when AC motor drive runs, fan
OFF when AC motor drive stops
3: Fan ON when preliminary heatsink
temperature attained
Factory
Setting
0.00
0
100
0
0
0
0
Revision August 2008, 2ELE, V1.02
Customer