Delta Electronics AC Motor Drive VFD-EL User Manual page 56

Parameter Explanation
Over-Torque
06.04
Detection Level
Over-Torque
06.05
Detection Time
Electronic Thermal
Overload Relay
06.06
Selection
Electronic Thermal
06.07
Characteristic
Present Fault
06.08
Record
06.09 Second Most
Recent Fault Record
Revision August 2008, 2ELE, V1.02
Settings
2: Enabled during constant speed operation.
After the over-torque is detected, stop
running.
3: Enabled during accel. After the over-torque
is detected, keep running until OL1 or OL
occurs.
4: Enabled during accel. After the over-torque
is detected, stop running.
10 to 200%
0.1 to 60.0 sec
0: Standard motor (self cooled by fan)
1: Special motor (forced external cooling)
2: Disabled
30 to 600 sec
0: No fault
1: Over current (oc)
2: Over voltage (ov)
3: IGBT Overheat (oH1)
4: Reserved
5: Overload (oL)
6: Overload1 (oL1)
7: Motor over load (oL2)
8: External fault (EF)
9: Current exceeds 2 times rated current
during accel.(ocA)
10: Current exceeds 2 times rated current
during decel.(ocd)
11: Current exceeds 2 times rated current
during steady state operation (ocn)
12: Ground fault (GFF)
13: Reserved
Chapter 4 Parameters|
Factory
Setting
150
0.1
2
60
0
Customer
4-13