Pm Timer Reload Events - Intel P965 User Manual

ACPI Function
This item allows you to Enabled/Disabled the Advanced Configuration and Power Management
(ACPI). The settings are Enabled and Disabled.
Video Off in Suspend
This determines the manner in which the monitor is blanked. The choice are Yes → Video will
off , and No→ Video always On.
Video Off Method
This determines the manner in which the monitor is blanked.
DPMS (default)
Blank Screen
V/H SYNC+Blank
Modem Use IRQ
This determines the IRQ in which the MODEM can use.
The settings are: 3, 4, 5, 7, 9, 10, 11, NA.
Soft-off by PWR-BTTN
Pressing the power button for more than 4 seconds forces the system to enter the Soft-Off state.
The settings are: Delay 4 Sec, Instant-Off.
Power On by Ring
During Disabled, the system will ignore any incoming call from the modem. During Enabled,
the system will boot up if there's an incoming call from modem.
Date(of month) Alarm
You can choose which month the system will boot up. Set to 0, to boot every day.
Time(hh:mm:ss) Alarm
You can choose what hour, minute and second the system will boot up.
Note:If you have change the setting, you must let the system boot up until it goes to the
operating system, before this function will work

PM Timer Reload Events

Please refer to section 3-8-1
3-8-1 PM Timer Reload Events
Primary IDE 0
Primary IDE 1
Secondary IDE 0
Secondary IDE 1
FDD, COM, LPT Port
PCI PIRQ [A-D] #
↑ ↓ → ←
Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit
F5:Previous Values
Initial display power management signaling.
This option only writes blanks to the video buffer.
This selection will cause the system to turn off the vertical and
horizontal synchronization ports and write blanks to the video buffer.
Phoenix – AwardBIOS CMOS Setup Utility
PM Timer Reload Events
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
F6:Optimized Defaults
Menu Level >>
F7:Standard Defaults
39
Item Help
F1:General Help