Sanremo ZOE COMPETITION Instruction Booklet page 21

ZOE COMPETITION
5.1 PRELIMINARY CHECK
Before using the appliance, check that:
- the plug is inserted properly into the mains power outlet;
- the water filling hose is correctly connected to the mains water outlet, check for leaks and
that the water tap is open;
- the drain pipe is positioned in accordance with the preceding instructions.
With the steam tap (B) open, place the ON/OFF switch (D) in the 1 position and wait for the
water in the boiler to reach the maximum level established by the electronic control unit. If the
boiler does not fill within the set time- out (90 secs.), the pump stops and the keypad LEDs
flash. In this case put the on/off switch (D) to position 0 and then to position 1 to finish filling
the boiler.
Now put the on/off switch (D) to position 2 so that the heating elements are powered and
therefore start to heat the water.
Wait for steam to come out the steam nozzle (B), then close the tap and, using the Boiler
pressure gauge, check that the pressure has reached and maintains a value of 0.8:1 bar.
5.2 INITIAL INSTALLATION AND WASHING
Activate the hot beverage appliance and bring it to the rated operating conditions, leaving
it statically "ready for operation" for 4 hours (nominal temperature and boiler pressure
conditions: 120 ° C - 1 bar). After 4 hours, dispense water from the groups and from the
boiler outlet and drain until the entire hydraulic circuit is empty so as to eliminate any initial
impurities.
Then load the unit again and bring it up to the rated operating conditions according to the
operating instructions.
5.3 HOT WATER DELIVERY
Make sure the boiler pressure gauge shows a pressure of 0.5:1 bars.
Press the button (M6) to deliver hot water, then press again to stop delivery. Take great care
to avoid burns.
5.4 STEAM DELIVERY
All models have two steam nozzles on the sides of the work surface, with the exception of
the one group machine which has just one. These steam nozzles are retractable and can
be oriented by means of a ball joint. To deliver steam, turn the knobs (B) anticlockwise. Take
great care to avoid burns.
5.5 COFFEE DELIVERY ZOE COMPETITION SED MODEL
Insert the filter holder (E) in its seat (F) by turning it anticlockwise. Select the type of delivery
required on the keypad (M):
M1=One short/standard coffee.
M2=One standard/long coffee.
M1=Two short/standard coffees.
M4=Two standard/long coffees.
M5=Electronic settings button or continuous manual delivery.
During the erogation the display (G) shows the total time for coffee extraction.
5. USE
21
ENGLISH