Basic Cleaning - SCHUNK TANDEM KSP3 Assembly And Operating Manual

Maintenance and care
Size
64
100
140
160
250

7.4.2 Basic cleaning

Disassembly
30 02.00 | KSP3, KSP3-LH, KSP3-F | Assembly and Operating Manual | en |
1463318
Central lubrication
• To use central lubrication, the set-screws of
• For proper lubrication, both supply lines
• The central lubrication system must be
• Only lubricate in the open position.
• After greasing, run through the complete
• Grease to be used and lubrication
WARNING
Risk of injury during disassembly of the product because of the
high spring pressure in the cover and the cylinder pistons (AS
variant).
• Only trained specialist personnel may disassemble the
clamping force block!
• The cover may only be removed with the aid of a suitable
disassembly device!
For basic cleaning, the product must be disassembled, cleaned and
reassembled. With the "PM" variant, the pneumatic jaw end
position control must also be set.
Before disassembling the product, switch off the machine and
secure it against being switched on again. Then remove all
compressed air lines. No residual energy may be left in the
product.
the factory sealed connections (6.7) must be
removed.
must be connected.
suitable for greases of NLGI 2 classification.
stroke several times.
intervals, } 7.3 [/ 29]
Grease quantity (per connection) [cm³]
2
4
4
4
4