Mounting The Clamping Block On The Base Plate - SCHUNK TANDEM KSP3 Assembly And Operating Manual

NOTE
• For vertical installation, the openings of the coolant drain (V)
must always face downwards
• Surface "X" is parallel to the guideway of the base jaws (item 2)
so the clamping force block can be aligned on the machine
table or to check the positioning.
Assembly with clamping sleeves:
Mount the clamping force block on the machine table together
with clamping sleeves (item 85) and screws (item 84).
Assembly with fitting screws:
There are two fittings in the housing (item 1) that, along with the
fitting screws (item 82), are used to center the clamping force
block on the machine table with repeat accuracy. Do not realign
the clamping force block after removing it from the machine table
(e.g., after replacing the seals). When using fitting screws (item
82), these are used instead of the clamping sleeves (item 85) and
two of the four screws (item 84).
Mounting with cylindrical pins (Z variant):
The clamping force block is fastened to the machine table with 4
screws (item 84). The two cylindrical pins (item 34) are used for
alignment with repeat accuracy. Do not realign the clamping force
block after removing it from the machine table (e.g., after
replacing the seals).

5.2 Mounting the clamping block on the base plate

(If the two parts are delivered separately)
When mounting TANDEM clamping force blocks on ABP-h, ABP-a
or SBP TANDEM base plates, use the shorter mounting screws
included in the base plate accessory kit instead of the standard
mounting screws (item 19) that come with the clamping force
block.
For KSP3 100, KSP3-LH 100 and KSP3-F 100:
Use the M8 x 30 screws from the base plate accessory kit instead
of the M8 x 35 screws (item 84).
For KSP3 160, KSP3-LH 160 and KSP3-F 160:
Use the M10 x 35 screws from the base plate accessory kit instead
of the M10 x 40 screws (item 84).
For KSP3 250, KSP3-LH 250 and KSP3-F 250:
Use the M12 x 40 screws from the base plate accessory kit instead
of the M12 x 45 screws (item 84).
02.00 | KSP3, KSP3-LH, KSP3-F | Assembly and Operating Manual | en |
1463318
Assembly and connection
19