Vid_Out Bus Sync Source Select Jumpers (Jp8.1/3/5, Jp8.2/4/6); Vid_Out Bus Sync Enable Jumper (Jp8.7/8); Av_Reset Source Jumper (Jp9.1/3/5) - Analog Devices Blackfin A-V EZ-Extender Manual

Jumpers
VID_OUT Bus SYNC Source Select Jumpers
(JP8.1/3/5, JP8.2/4/6)
The source of the PPI frame sync signals depends on the PPI port driving
the bus. When using
VID_OUT
. When using
JP8.2/4

VID_OUT Bus SYNC Enable Jumper (JP8.7/8)

To enable the

AV_RESET Source Jumper (JP9.1/3/5)

The source of ICs reset on the Blackfin A-V EZ-Extender is controlled by
either a flag pin or a system reset; the latter also resets the Blackfin proces-
sor (see Table
Table 2-9. Jumper Reset Sources
Jumper Location
JP9.1/3
JP9.3/5
Uninstalled
2-14
PPI0
, place the jumpers at
PPI1
frame sync signals, install
VID_OUT
2-9).
Reset Source
Flag pin multiplexed with
System reset generator
ICs are not reset
, place the jumpers at
JP8.3/5
JP8.7/8
PPI1_D11
Blackfin A-V EZ-Extender Manual
and
JP8.1/3
and .
JP8.4/6
.