Power Connector; European Power Supply Specifications; Jumpers; Bus Mode Selection Jumpers (Jp1) - Analog Devices ADSP2192-12 EZ-KIT LITE Manual

4.4.1 Power Connector

The power connector supplies DC voltages to the EZ-KIT Lite board. Table 4-1 shows the power
connector pin out.

4.4.2 European Power Supply Specifications

Below is the description of the Power Supply that must be provided if the EZ-KIT Lite is used in
USB mode or Stand-alone mode.
DC VOLTAGE
CURRENT
RIPPLE
DC CONNECTOR
Plug Size:
Polarity:

Table 4-2: External Power Supply Specifications

4.5 Jumpers

4.5.1 Bus Mode Selection Jumpers (JP1)

The Bus Mode Jumpers (JP1) are used to configure the BUS [1:0] pins on the ADSP2192-12 DSP.
In order to use the board in Stand Alone Mode the DSP must be placed in Sub-ISA mode.
Below are the different configurations for the BUS pins.
NOTE: Use this Jumper in conjunction with JP5 and SW4 to properly set-up the board.
ADSP2192-12 EZ-KIT Lite Evaluation System Manual
www.BDTIC.com/ADI
Terminal Connection
+7.5-12 VDC@2amps
CENTER
PIN
Outer Ring GND

Table 4-1: Power Connector Pin-out

7.5V +/- 5% (Full Load)
2 Amps (Maximum Rating)
500 mV rms (Max @ Full Load)
Type: Switchcraft 760 style, FEMALE
5.5 (OD) V 2.5 (ID) X 9.5 (length) millimeters
Center is Positive (inside terminal)
4-3