Table of Contents
Advertisement
CHARGE CABLE WRAP GUIDELINES
The ACS enclosure body is sculpted to allow the charge cable to
be wrapped around it for convenient storage as well as to keep
the bulk of the cable off of the ground and out of the way. As the
charge cable is comprised of a number of wires, coiling the charge
cable too tightly around the ACS enclosure will result in the charge
cable feeling warmer to the touch than would ordinarily be the
case.
To minimize this effect, it is recommended that the charge cable
be loosely draped around the ACS enclosure body with larger
loops. This will also permit greater convenience in "pulling off"
additional loops if a longer charge cable reach is desired.
Figure 8: Drape the Charge Cable Loosely Around the ACS
Enclosure
MOVING & STORAGE INSTRUCTIONS
Note that the hardwired ACS is intended for fixed installations. For
mounting requirements, consult the Mounting Procedures section
in this manual.
Aways turn off input power to the EVSE at the circuit breaker
panel prior to hard-wiring an ACS to or disconnecting an ACS
from the service lines.
When transporting the EVSE, do not lift or carry the entire unit by
the SAE J1772 charge cord. Likewise, do not lift or carry the entire
unit by the flexible conduit and input conductors. The EVSE has
a non-operational storage temperature range of -40°C to +80°C
(-40°F to +176°F).
Page 31
ACS User Manual
Advertisement
Table of Contents
