Mounting The Sae J1772 Connector Holster - enphase CLIPPERCREEK ACS User Manual

Table of Contents

Advertisement

MOUNTING THE SAE J1772 CONNECTOR
HOLSTER
The SAE J1772 connector holster comes standard to provide a
convenient, protective housing for the SAE J1772 connector head
when it is not in use.
The SAE J1772 connector holster should be placed so that
users have easy and safe access to the SAE J1772 connector.
For indoor installation, mount the SAE J1772 connector holster
between 18 and 48 inches above the ground or grade.
For outdoor installation, mount the SAE J1772 connector
holster between 24 and 48 inches above the ground or grade.
The SAE J1772 connector holster has two vertically aligned
mounting holes spaced 5.45" apart, one each on the enclosure
top and bottom. Use a ruler or template to mark hole locations
on the mounting surface.
The vertical alignment of the ACS and SAE J1772 connector
holster mounting holes allows for the convenient mounting
of both components onto the same post or wall structure. For
example, the holster may be mounted directly above the ACS.
Place the SAE J1772 connector holster such that both
mounting holes can take advantage of solid structural framing
inside of the wall or a strong wall surface such as plywood.
A set of exterior wood screws and stainless steel washers are
included for the purposes of mounting the SAE J1772
connector holster to a wooden surface.
For mounting to a solid surface such as concrete, brick, or
stone, alternate hardware may need to be procured. Examples
of solid-wall mounting hardware include multi-sets, wedge
anchors and sleeve anchors. Use the type of mounting
hardware most appropriate for the supporting structure.
Page 29
ACS User Manual

Advertisement

Table of Contents
loading

Table of Contents