Table of Contents
Advertisement
Figure 4–10: New/Edit Profile screen, Drawing Mode
Use the "+ Point" function to add inflection points to the profile, or remove them using the "- Point"
function by tapping on the profile line. You can change the location of inflection points by first
tapping on the point, and then tapping on the desired new location. You can create any desired
profile by this means.
Function details:
• Define Pressure Grade (High, Middle, Low) – Appears when you initiate any New/Edit Profile
mode, allowing you to select the pressure scale displayed on the y axis. Once you make a
pressure grade selection, the New/Edit Profile screen opens with the upper limit set to the
selected range.
Figure 4–11: Define Pressure Grade dialog box, all modes
• + Point – Adds a new profile inflection point.
• III – Works like a slider to increase or decrease the time.
• - Point – Removes a profile inflection point.
• Left Arrow and Right Arrow – Increases or decreases the profile time as reflected on the x
axis.
July 1, 2021, 715006867 Ver. 01
Page 28
Advertisement
Table of Contents
