Instructions On Removing And Installing The Rear Housing Cover; Hanging Arm Installation - Hisense HMD2C21A User Manual

Instructions on Removing and Installing the Rear Housing Cover

Removal procedure
1) Open the snap-fit joint marked with ③ on the cover.
2) Put your hand in the position marked with ④ and force open the snap-fit joint marked with ②.
3) Remove the cover.
Installation procedure
1) Insert the part of the cover marked with ① into the rear housing.
2) Press tight the snap-fit joint marked with ② on the cover.
3) Press tight the snap-fit joint marked with ③ on the cover.
The following figure shows the rear housing with the cover correctly installed.

Hanging Arm Installation

Remove the base assembly to install the required hanging arm or base.

Follow the instructions in the User Guide when installing the hanging arm or base.
| Hisense Product User Guide | Installation | 8
Installation