Output 3/5 Screen; Output 4/5 Screen - Panasonic AW-UE80WP Operating Instructions Manual

Camera menu items (continued)

Output 3/5 screen

O u t p u t 3 /5
O S D M i x
3 G S D I
H D M I
N D I
I P / N D I |HX
R e t u r n
OSD Mix
Selects whether to turn Off/On the camera menu and status displays.
3G SDI [Off, On]
Selects whether to turn this Off/On for images output from 3G SDI
OUT connector.
HDMI [Off, On]
Selects whether to turn this Off/On for images output from HDMI
connector.
NDI [Off, On]
Selects whether to turn this Off/On for images of NDI output from the
LAN connector.
IP/NDI|HX [Off, On]
Selects whether to turn this Off/On for images other than NDI images
(H.264/H.265/JPEG/RTMP/SRT/NDI|HX) output from the LAN
connector.
Off The camera menus and statuses are not displayed on the
output pictures covered by the setting items listed above.
On The camera menus and statuses are displayed on the
output pictures covered by the setting items listed above.
<NOTE>
• When this is set to [Off], the camera menu can be displayed for
about 1 minute after the unit is turned on.
Return
Return to the previous menu level.

Output 4/5 screen

O S D O f f W i t h R - T a l l y
On O S D S t a t u s
On T a l l y
On T a l l y L E D L i m i t
On R
G
T a l l y B r i g h t n e s s
R e t u r n
OSD Off With R‑Tally [Off, On]
Off or on the function that turns off camera menu, status and other
displays when red tally signals are received via commands or
contacts.
When the red tally signal releases, the camera menu display will
return.
OSD Status [Off, On]
Turn the status display during AWB and ABB off/on, or error display
when an error occurs.
Tally
[Enable, Disable]
[Disable] or [Enable] is set here for the function which turns on or
turns off the tally lamp using the tally control signal.
Tally LED Limit
Sets whether to limit the lighting of the tally lamp for each of the tally
control signal colors (R/G).
R [Limit, Unlimit]
G [Limit, Unlimit]
Limit
Unlimit
<NOTE>
• If [Limit] is selected for [Tally LED Limit], only the tally lamp of this
unit is limited. The tally status display on external devices (the AW-
RP150, AW-RP60 controller, etc.) remains enabled.
Tally Brightness [Low, Mid, High]
Adjust the brightness of the tally LED.
Return
Return to the previous menu level.
62
O u t p u t 4 / 5
Limit the lighting of the tally lamp.
Light the tally lamp.
O f f
O f f
E n a b l e
U n l i m i t
U n l i m i t
L o w