Collaboration Capability [Linkage] - Panasonic AW-UE80WP Operating Instructions Manual

Web screen configurations (continued)
Preset Iris [Off, On]
When the preset memory is played back, set whether the
reproduction of the values in the various menus related to Iris is off/
on.
When set to [On], the values set in the various menus below are
reproduced when preset memory is played back.
- Picture Level
- Iris Mode
- Auto Iris Speed
- Auto Iris Window
Factory settings: Off
<NOTE>
• Its setting takes effect when [Mode A] or [Mode B] has been
selected as the [Preset Scope] setting.
Preset Shutter [Off, On]
When the preset memory is played back, set whether the
reproduction of the Shutter setting value is Off/On.
Factory settings: On
<NOTE>
• This is enabled when [Preset Scope] is [Mode A].
• The Shutter values are reproduced only when the frame rate when
the preset memory was registered and the frame rate when playing
back the preset memory match.
Preset Zoom Mode [Mode A, Mode B]
Select the zoom operation for when preset memory is recalled.
Mode A Perform the zoom operation in line with the pan/tilt
operation.
Mode B Perform the zoom operation quicker than the pan/tilt
operation.
Factory settings: Mode A
Freeze During Preset [Off, On]
Turn the function for freezing images during preset playback off/on.
When this is set to [On], preset playback is performed with a still of
the image immediately preceding the start of preset playback being
output. The image freeze is released when preset playback is finished.
Factory settings: Off

Collaboration capability [Linkage]

Tracking data output settings screen [Tracking
„ „
Data Output]
Select the output mode of the tracking data and the communication
destination in the IP mode.
Up to four addresses can be specified when the IP mode is enabled.
z Setting status
„
Displays the output mode of tracking data and the destinations in IP
mode.
z Connection type
„
Serial [On, Off]
Sets the function [On] or [Off] to output the tracking data, such as
Pan/Tilt/Zoom or other information from Serial Output (RS-422),
synchronized with the Genlock signal. (→ page 59)
When [Serial] is set to [On], a warning message is displayed. Click
the [OK] button to enable the settings.
Factory settings: Off
<NOTE>
• The serial connection of the remote controller (AW-RP150 or
AW-RP60 etc.) cannot be made if [Serial] is already [On].
• In the following cases, the tracking data output may be delayed or
the value may not be updated.
- While viewing the OSD menu
- While recalling the preset value during an ongoing preset recall
- When executing AWB/ABB
- When a red or a green tally signal input has been changed
between Off and On
- When deleting a preset memory
- When an output image is flipped (turned upside down or left-right
reversed)
- After switching [Scene]
- After switching [Iris Mode]
- After switching [Super Gain]
- After switching [White Balance Mode]
- After switching [Gamma Mode]
- After switching [Matrix Type]
- After switching [Focus Mode]
- After switching [Zoom Mode]
- After switching [Max Digital Zoom]
- After switching [Digital Extender]
- After switching [Fan]
- After switching [OSD Mix]
- After switching [Tally]
- After switching [Install Position]
122