Black Balance Adjustment; Automatic Adjustment - Panasonic AW-UE80WP Operating Instructions Manual

Black balance adjustment

Adjust the zero levels of the three primary colors (RGB) to reproduce
black accurately. If the black balance is out of adjustment, not only will
black be reproduced poorly, but the color tones of the screen as a whole
will also be degraded.
Readjustment of the black balance is not required under normal
circumstances but is necessary in the following situations.
• Perform adjustment when using the unit for the first time or when
the unit has not been used for a prolonged period.
• Perform adjustment when the ambient temperature changes
significantly, such as during changes of the season.
<NOTE>
• After adjusting the black balance, and [Serial] or [IP] of [Tracking Data
Output] is set to [On], the tracking data output may be delayed or the
value may not be updated. (→ page 59)

Automatic adjustment

When performing operations from a wireless
remote control
In Step 9 for "Automatic adjustment" (→ page 40) of "White
balance adjustment", when you press and hold the <SET> button for
approximately 2 seconds, auto black balance adjustment (ABB) is
executed and the black balance is set.
When this takes place, the lens is closed and then the adjustment is
performed so the screen will temporarily turn black.
• When the black balance adjustment is completed successfully, the
"ABB OK" message appears at the center of the screen.
AB B OK
<NOTE>
• Adjustment cannot be performed while the color bar is displayed.
Switch to the camera image by pressing the <MODE> button.
• The black balance cannot be adjusted during preset playback.
When performing operations from a controller
When using an AW‑RP150 or AW‑RP60
For details, refer to the operating instructions for the controller.
42