CAME BPT DVC/01 Programming Manual page 11

Deleting Codes and Tags
1
2
12345 12345
+
5
beep beep
>10'' >10''
6
beep beep
>1'' >1''
7
12345 12345
+
8
Position the power supply's PROG RFID jumper at "–" 1: the power supply's PROG LED
will fl ash slowly, along with the message LEDs with the confi guration in fi g. 2. If the
LEDs immediately go out it means there is a malfunction in the connections between the
power supply and the entry panel. Check the connections and return to programming.
3
+
beep beep
Codes. Press
pad of any entry panel that has already been addressed 5 and, after the confi rmation
beep, repeat this once again to confi rm: ALL the codes relating to the GROUP will be
deleted.
Badges and Codes. Entry panels with buttons: hold down for at least 10 seconds the
call key 6 relating to the GROUP for which the codes are to be deleted and, after the
beep, press the key again (briefl y) 7. In this way ALL the GROUP's codes and badges
of any type will be deleted.
Entry panels with DNA. Enter the call code followed by the
GROUP for which the codes are to be deleted and, after the beep, enter the call code
again followed by the
be deleted.
Finally, reposition the PROG RFID jumper in the rest position J: the procedure is
NOT terminated automatically!
beep beep
12345 12345
9
beep beep
Badge. Bring a badge/tag up to the reader of any entry panel that
has already been addressed 3 and, after the confi rmation beep,
repeat this once again to confi rm 4: ALL the badges relating to
the GROUP will be deleted.
, enter the access code (4-8 fi gures) followed by the
key 9. In this way ALL the GROUP's codes of any type will
beep beep
+
4
key on the key-
8 key related to the
J
beep beep