CAME BPT DVC/01 Programming Manual page 12

PROGRAMMING ENTRY PANELS WITH VAS/100.30 or VAS/101
First Programming
>3'' >3''
PROG
<6'' <6''
B
B
1
M1
2
3 B
4
5
beep beep
6
1-2-3 1-2-3
+
7
Entering Programming Mode. Press the PROG key 1 for at least 3 seconds and
release within 6 seconds. If the PROG LED immediately goes out it means there is a
malfunction. Check the connections and return to programming. The LEDS on the entry
panels light up as shown in fi gure 2. Wait 5 seconds for the auto test to be completed
CN4
and continue as shown below.
3
Programming Type of Keys. Press the fi rst key on the entry panel 3/3A/3B until
LED stops fl ashing along with the backlighting LEDs 4.
the
Should call keys be present ONLY ON ADDITIONAL BUTTON PANELS, the oper-
ation shown in fi gure 3 is carried out on these as shown in fi gure 3C.
1
2
3
4
5
6
7
8
9
10
Programming the call keys. Press the door release
the entry panel, press the call key to be linked to the receiver 6: a beep will confi rm
that the setting has been stored. Continue, repeating the same operations for all the
other receivers.
Programming the door release code and relay with DNA. Press
relay code you wish to programme (press key 1 to activate the door opening control in
the entry panel; press key 2 to activate relay 1 on the VLS/2 relay module; press key 3
to activate relay 2 on the VLS/2 relay module) 7. Press
desired code (from 3 to 5 fi gures). Once programming has been completed, by pressing
the key plus the desired code and
and relay 1 or 2 8.
Exiting Programming. Briefl y press the PROG key I: the PROG LEDs and entry panel
LEDs will go out. NOTE. If no action is performed, the procedure will end automatically
after 30 minutes.
8
1
2
3
4
5
6
7
8
9
10
3 C
it is possible to activate the door opening control
12345 12345
+ +
3 A
and AUX2 buttons 5. On
and key in the
once again and key in the
beep beep