CAME BPT DVC/01 Programming Manual page 14

<1'' <1''
PROG
B
B
7
M1
>3'' >3''
PROG
<6'' <6''
B
B
8
M1
9
J
The product complies with the relevant directives in force.
Decommissioning and disposal. Dispose of the packaging and the device responsibly at the end of its life cycle, in compliance with the laws in force
in the country where the product is used. The recyclable components are marked with a symbol and the material's ID marker.
THE DATA AND INFORMATION SHOWN IN THIS MANUAL ARE TO BE CONSIDERED AS SUBJECT TO CHANGE AT ANY TIME AND WITHOUT THE NEED
FOR ANY ADVANCE WARNING. MEASUREMENTS, UNLESS OTHERWISE INDICATED, ARE IN MILLIMETRES.
Exiting Programming. Briefl y press the PROG key 7: the PROG LEDs and entry panel
LEDs will go out. If no action is performed, the procedure will end automatically after
30 minutes.
CN4
Programming Type of Keys. In "Programming Call Keys" 2 press the PROG key 8
and release it within 6 seconds to go into the "Programming Type of Keys" procedure
I. Press one of the fi rst 4 "keys" on the fi rst entry panel, the
as will the backlighting LEDs of the fi rst 4 positions of the call keys J. The messages
will take on the confi guration in K. Finally, to exit programming, briefl y press the PROG
key K: the PROG LEDs and the LEDs on the entry panels will go out. If no action is
performed, the procedure will end automatically after 30 minutes.
CN4
Programming entry panel video cameras. While programming the call keys the
"visual range" of the video camera can be adjusted in the way already described.
Entry panel brightness level adjustment. While programming the call keys the entry
panel brightness level can be adjusted in the way already described.
Should call keys be present ONLY ON ADDITIONAL BUTTON PANELS, proceed as
shown in the NOTE on page 12.
K
LED will stop fl ashing,