CAME BPT DVC/01 Programming Manual page 13

PROG
<1'' <1''
B
B
9
M1
J J
0
100 °
6
82 °
1÷9
4
72 °
54 °
8
K
Reprogramming Procedure
>3'' >3''
PROG
<6'' <6''
B
B
1
M1
2
1-2-3 1-2-3
+
5
12345 12345
+
6
Programming entry panel video cameras. While programming the call keys the
"visual range" of the video camera can be adjusted from any receiver (with handset
raised, it there is one), by pressing the "Self-connection"
settings it is possible to scroll through the following ones K by pressing the AUX1
CN4
key, or to go back to the previous ones with the AUX2
automatically.
Entry panel brightness level adjustment. While programming the call keys the entry
panel brightness level can be adjusted from any receiver. Pressing the "Self-connection"
key on the receiver activates the video camera of the entry panel for which the bright-
ness level is to be adjusted. The brightness level can be increased/decreased by using
a previously assigned call key, or by simulating a call from DNA.
2
7
5
1
9
3
L
Entering Programming Mode. Press the PROG key 1 for at least 3 seconds and
release within 6 seconds. If the PROG LED immediately goes out it means there is a
malfunction. Check the connections and return to programming. The LEDS on the entry
panels light up as shown in fi gure 2. Wait 5 seconds for the auto test to be completed
CN4
and continue as shown below.
3
Programming the call keys. Press the door release
the entry panel, press the call key to be linked to the receiver 4: a beep will confi rm
that the setting has been stored. Continue, repeating the same operations for all the
other receivers.
Programming the door release code and relay with DNA. Press
relay code you wish to programme (press key 1 to activate the door opening control in
the entry panel; press key 2 to activate relay 1 on the VLS/2 relay module; press key 3
beep beep
+
4
to activate relay 2 on the VLS/2 relay module) 5. Press
again and key in the desired code (from 3 to 5 fi gures). Once
programming has been completed, by pressing the
the desired code and it is possible to activate the door opening
control and relay 1 or 2 6.
key 8. From the default
key L: the setting is saved
beep beep
and AUX2 buttons 3. On
and key in the
once
key plus