Checking For Blockages - Shark DuoClean Powerfins IZ300EU Series Instructions Manual

MAINTAINING YOUR VACUUM
FLOOR NOZZLE FLOOR NOZZLE
If any hair is wrapped around the brushroll, continue cleaning using the Carpet setting on a bare floor surface,
a low-pile carpet, or a small area rug� If some fibers remain wrapped around the brushroll after continued
use, carefully remove them� If you run over a hard or sharp object or notice a noise change while vacuuming,
check for blockages by following the steps under 'Checking for Blockages in the Floor Nozzle' on the bottom
right of this page�
CLEANING SOFT ROLLER
52
s h a r kc l e a n . e u
1 To remove Soft Roller from nozzle, pull the Soft Roller out by
the tab�
2 Tap loose debris off the Soft Roller� Use a dry towel to wipe
the Soft Roller clean and to remove any debris caught in the
teeth behind the Soft Roller�
3 Hand wash the Soft Roller as needed� Use only water, and let
air-dry completely, which should take at least 24 hours�
4 Reinsert the Soft Roller�
MAINTAINING YOUR VACUUM

CHECKING FOR BLOCKAGES

Checking for Blockages in the Handheld Vacuum:
1. Turn off vacuum�
2. Remove the handheld vacuum from the wand�
3. Check all intake openings on the dust cup and remove
any debris or blockage�
Checking for Blockages in the Wand:
Standard Wand:
1. Turn off vacuum�
2. Remove the handheld
vacuum and floor nozzle�
3. Check intake openings for
blockages and debris�
4. Clear away debris and
blockages�
Checking for Blockages in the Floor Nozzle:
1. Turn off vacuum�
2. Detach the wand�
3. Use the edge of a coin to open the three locks on the
bottom of the floor nozzle�
4. Remove the cover and tilt back the neck of the floor
nozzle�
5. Check the opening and remove any debris�
6. Replace the cover by sliding the inserts into the slots, then
pressing down firmly on all sides before turning the locks
clockwise to close, until they click securely into place�
Flexology® Wand:
1. Turn off vacuum�
2. Remove the handheld
vacuum and floor nozzle
from the wand�
3. Check the Clog Access
Hose on the Flexology
section of the wand by
pinching the tabs on both
sides of the hose and
lifting the hose out�
4. Clear any debris and
blockages�
53
s h a r kc l e a n . e u