Nozzle Maintenance; Checking For Blockages In The Vacuum - Shark BU1000 Series Owner's Manual

MAINTAINING YOUR VACUUM

NOZZLE MAINTENANCE

POWERFIN FLOOR NOZZLE
1. Turn off the vacuum.
2. Press the nozzle release button to detach
the nozzle from the wand.
3. Press the brushroll release button and
slide the brushroll out of the nozzle.
4. Clear any blockages and remove any
debris from the brushroll and floor nozzle.
50
sh a rkclea n.e u
5. Tap off loose debris and wipe the brushroll
clean with a dry towel. Hand wash the
brushroll if needed, using only water,
and then let it air dry completely for at
least 24 hours.
6. When the brushroll is dry, reinstall it into
the nozzle by inserting it into the nozzle
until it clicks.
MAINTAINING YOUR VACUUM

CHECKING FOR BLOCKAGES IN THE VACUUM

If you run over a hard or sharp object or notice a noise change while vacuuming, check for
blockages or objects caught in the brushroll.
Checking for Blockages in
Checking for Blockages in the
the Wand:
Hand Vacuum:
1. Turn off the vacuum.
1. Turn off the vacuum.
2. Detach the hand vacuum and
2. Remove the hand vacuum from the
floor nozzle from the wand.
wand.
3. Check both ends of the wand for
3. Check all intake openings to the
blockages and debris.
dust cup and remove any debris
or blockages. 4. Clear away any debris or
blockages.
Checking for Blockages in the
Floor Nozzle:
1. Turn off the vacuum.
2. Detach the wand from the floor
nozzle.
3. Press the brushroll release
button and slide the brushroll
out of the nozzle.
4. Clear any blockages and release
any debris from the brushroll
and floor nozzle.
5. Slide the brushroll back into the
nozzle, ensuring everything is
lined up and in place.
51
s ha rkc lea n.eu