Important Safety Warning; Transportation; Preparation; Installation - LEGRAND Numeric Onfiniti User And Installation Manual

3. IMPORTANT SAFETY WARNING

Please read the following instructions carefully before installing the unit and strictly comply with all the
warnings and operating instructions herein. Save this manual for future reference and do not operate this unit
before reading through all safety information and operating instructions carefully.

3-1. Transportation

• Please transport the UPS system in the original package only to protect against shock and impact.

3-2. Preparation

• Condensation may occur if the UPS system is moved directly from a cold to warm environment.
The UPS system must be absolutely dry before being installed. Please allow at least two hours for the UPS
system to acclimatize to the environment.
• Do not install the UPS system near water or in moist environments.
• Do not install the UPS system where it would be exposed to direct sunlight or near a heater.
• Do not block ventilation holes in the UPS housing.

3-3. Installation

• Do not connect appliances or devices which would overload the UPS system (e.g. laser printers) to
the UPS output sockets.
• Do not place cables in such a way that one can step on or trip over them.
• Do not connect domestic appliances such as hair dryers to UPS output sockets.
• The UPS can be operated by any individual with no previous experience.
• Connect the UPS system to an earthed shock-proof outlet which must be easily accessible and
close to the UPS system.
• Use only VDE-tested, CE-marked, ISI-marked mains cable (e.g. the mains cable of your computer)
to connect the UPS system to the building wiring outlet (shock-proof outlet).
• Use only VDE-tested, CE-marked, ISI-marked power cables to connect the loads to the UPS system.
• When installing the equipment, it should ensure that the sum of the leakage current of the UPS
and the connected devices does not exceed 3.5 mA.
• UPS is designed for linear load, worst case inductive resistive load.
3