Installing The Transformer - Cal Flame LTR20081044 Owner's Manual

The grill unit must be used with the gas pressure regula-
tor. The regulator will control and maintain a uniform gas
pressure in the manifold. The burner orifices have been
sized for the gas pressure delivered by the regulator.
WARNING: Attempting to operate the grill unit without
the gas regulator installed could cause an explosion and
possible death.
LP Gas Hook Up
An enclosure for an LP gas cylinder shall be vented by
openings at the level of the cylinder valve and at floor
level. The effectiveness of the openings for purposes of
ventilation shall be determined with the LP-gas supply
cylinder in place. This shall be accomplished in one of
the following manners:
1. One side of the enclosure shall be completely
open.
2. Enclosures that have four sides, complete with a top
and bottom:
a. At least two ventilation openings at cylinder
valve level shall be provided in the sidewall,
equally sized, spaced at 180º (3.14 rad), and
unobstructed. Each opening shall have a to-
tal free area of not less than 7.1 cm²/kg (one
square inch per pound) of stored fuel capacity,
and not less than a total free area of 64.5 cm²
(10 square inches).
b. Ventilation openings shall be provided at floor
level and shall have a total free area of not less
than 7.1 cm²/kg (one square inch per pound)
of stored fuel capacity and not less than a to-
Cal Flame 2008 Owner's Manual
LTR20081044, Rev. A
Installation / Assembly
tal free area of 64.5cm² (10 square inches). If
ventilation openings at floor level are in a side-
wall, there shall be at least two openings. The
bottom of the openings shall be at floor level
and the upper edge no more than 127 mm (5
inches) above the floor. The openings shall be
equally sized, spaced at 180º (3.14 rad) and un-
obstructed.
c. Every opening shall have minimum dimensions
so as to permit the entrance of a 3.2 mm (1/8
inch) diameter rod.
Transporting and Storing LP Gas
Transport only one cylinder at a time. Ensure the cylinder
is secured in an upright position with the control valve
turned off and the dust cap in place. Store cylinders out-
doors and out of reach of children. Do not store cylinders
in a building, garage, or any other enclosed area.

Installing the Transformer

All grills with electrical components such as lights or a
convection fan will require the transformer to be installed
and plugged in before you can use it. This needs to be
done before the grill is inserted in the barbecue island.
When the transformer is attached to the grill chassis,
use care in placing the grill in the island cutout to avoid
hitting the transformer.
Page 5