Fukuda Denshi Dynascope 8000 Series Maintenance Manual page 30

Safety
CAUTION
 If monitoring of a new patient is started without discharging the previous patient, data of the new patient will
be added to the data of the previous patient which will result in inaccuracy.
 The user mode setting (alarm/display configuration) will remain effective even when the power is turned OFF
or when the patient is discharged. Before monitoring, make sure the current user mode is suitable for the
patient's condition.
 Resuming monitoring will also resume the alarm in suspension.
CAUTION
 Use only the specified SD card.
 Use only the SD card formatted on this equipment.
 Make sure to power cycle the system after the setup data is read from the SD card.
By power cycling the system, the read data will become effective.
 Do not leave the SD card in reach of patients or infants.
CAUTION
 When cleaning the touch panel, never use strong-acidic cleaning solution.
 To clean the touch panel, use an optional cleaning cloth, eyeglass cleaning cloth, soft cotton cloth, or non-
woven cloth (pulp, rayon, polyethylene, etc.).
 Clean the equipment frequently so stains can be removed easily.
 To prevent injury, it is recommended to wear gloves when cleaning the equipment.
 Pay attention not to allow chemical solution to enter the equipment or connectors.
 Do not use organic solvents, thinner, toluene or benzene to avoid damaging the resin case.
 Do not polish the equipment with abrasive or chemical cleaner.
 When disinfecting the entire room using a spray solution, pay close attention not to get any solution into the
equipment or connectors.
 Use only neutral detergent to clean the equipment. The surface resin coating may damage, resulting in
discoloration, scratches, and malfunction.
Example:
chemical cloth, scrub brush, abrasive, polishing powder, hot water, volatile solvent and chemicals (cleanser,
thinner, benzine, benzol, and synthetic detergent for house and furniture), or sharp-edged tools
 Do not open the housing.
 Do not allow alcohol or other liquids to enter the equipment.
 Replace the periodic replacement parts periodically as specified.
xvi
Precautions about the Patient Admit/Discharge
Precautions about the SD Card
Precautions about the Maintenance
Precautions for Using the Equipment