EAS Electric EMV72PGN Instruction Manual page 69

Removing the door cover
The plastic inlay in the door cover may become discolored. To carry out thorough
cleaning, you can remove the cover.
Remove the appliance door like instructed above.
Press on the right and left side of the cover.
1.
Remove the cover.
2.
3.
After removing the door cover , that rest parts of the appliance door can be easily
taken off so that you can go on with the cleaning . When the cleaning of the
appliance door has finished , put the cover back in place and press on it until it clicks
audibly into place.
4. Fitting the appliance door and close it.
Caution!
While the appliance door is well installed, the door cover can also be taken off, by this time.
Removing the door cover means to set the inner glass of the appliance door free,
1.
the glass can be easily moved and cause damage or injury.
As removing the door cover and inner glass means to reduce the overall weight of
2.
the appliance door. The hinges can be easier to be moved when closing the door
and you may be trapped. Keep your hands away from the hinges.
Because of the 2 points above, we strongly recommend you not to remove the door
cover unless the appliance door removed. Damage caused by incorrect operation is not
covered under warranty.
Rails
When you want have a good cleaning for the rails and cavity, you can remove the
shelves and clean it. In this way your appliance will retain its appearance and remain
fully functional for a long time .
1. Pull the front part of the side rails horizontally to the opposite direction until the
feature gets out ; Later on you can remove the shelves out like the picture below .
into the holes of cavity rightly first of all , then insert the feature back into To put the
side rails back to the cavity , to make the back part of the shelves insert the cavity.
27 V.1