Table of Contents
Advertisement
Step 3:
Assembly of the Cable Arm Assembly
1.
Assemble the cable arm assembly (11) to cable arm connector (17) by using two bolts (103) and
two washers (116).
2.
Assemble the cable arm connector (17) to front upright (3) by using two bolts (97), four washers
(116) and two nylon nuts (124).
3.
Assemble the cable arm assembly (11) and stabilizing plate (20A) to base
frame (1) by using two bolts (98A), four washers (116) and two nylon nuts
(124).
NOTICE
L
You may need to loosen the bolts at the top of the cable arm assembly bottom frame so that
the holes line up.
4.
Slide the axle of each cable arm (14) through the holes on the selector plate in the cable arm
assembly (11) and fasten them by using two spacers (34) and two axle collars (35).
5.
Tighten two set screws (112) on the axle collars (35) with an
allen wrench.
࣑ ATTENTION
Make sure that each cable arm (14) pivots freely and
that cables are not twisted.
17
Advertisement
Table of Contents
