Table of Contents
Advertisement
Step 4:
Assembly of the Press Station
1.
Attach the press arm support (13) to the top frame (2) by aligning the holes and inserting one
bolt (95) with two washers (115) and one nylon nut (123).
2.
Attach four end caps (68) to the press arm support (13).
3.
Attach press arm (7) to the press arm support (13) by aligning the holes and inserting the press
arm axle (28).
4.
Tighten the two pre-assembled set screws (112) on the press arm (7).
5.
Make sure the longer pop pin (85) is seated in one of the adjustment holes on the press arm
support (13).
6.
Attach two end caps (69) to the press arm (7).
18
GX
Advertisement
Table of Contents
