BodyCraft Multi Gym GX Assembly And Operating Instructions Manual page 29

Step 10: Assembly of the Cable Arm Cable
NOTICE
L
The cable arm cable (91) is already routed through the cable arms (14).
1. Assemble pulleys P3 and P7, along with their pulley guide brackets (32) to the cable arm
assembly (11) by using one bolt (101) and one nylon nut (124) each.
2. Route the cable above these pulleys. Tighten these nuts, making sure the pulley guide brackets
(32) do not rub against the cable.
3. Continue routing, on both sides, down and around pulleys P4 and P6. Assemble pulleys P4 and
P6 to the base of the cable arm assembly (11) by using one bolt (96), two pulley guide brackets
(32) and one nylon nut (124). Tighten this nut, making sure the pulley guide brackets (32) do not
rub against the cable.
4. Route the cable up to pulley P5. Assemble pulley P5 inside the pulley block (20) by using one
bolt (101), the cable guide plate (25) and one nylon nut (124). Loosely hook the cable guide
plate (25) to the connect cable (90), directly behind that.
29