Table of Contents
Advertisement
Step 9:
Assembly of the Connect Cable
1.
Hook the steel ball end of the connect cable (90) to the receptor C1 welded to the base frame
(1).
2.
Route the cable up and over pulley C2. Assemble pulley C2 to the bottom of the double pulley
block (19) by using one bolt (101) and one nylon nut (124).
3.
Screw the threaded end of the cable half way into the threaded receptor on the pulley block
(20). The threaded end of the cable is an adjustment point but should always have at least one
third of the threads screwed into the pulley block (20).
28
GX
Advertisement
Table of Contents
