BodyCraft Multi Gym GX Assembly And Operating Instructions Manual page 22

࣑ ATTENTION
+ If you purchased the optionial leg press, please orient the floating pulley block (21) with the
threaded end down and the flat side up (as described in the leg press manual).
13. Route the cable over pulley T11. Assemble pulley T11 to the top frame (2) by using one bolt
(101) and one nylon nut (124).
14. Route the cable through the looped end of the selector pin lanyard. Screw the threaded end of
the top cable into the top plate (about half way down).
NOTICE
L
The threaded end of the cable is an adjustment point but should always have at least one third
of the threads screwed into the top plate.
22
GX