Performing Debug Using Symbols - Renesas SKP16C62P User Manual

6.9 Performing Debug Using Symbols

Normally when a new project is started using HEW, debugging symbols are enabled. If you are
unable to debug your program using symbols in KD30, add the debug option [-g] in HEW before
compiling the programs. To enable the [-g] option, perform the following:
•
•
•
•
•
•
For more information, see the HEW user's manual.
SKP16C62P User's Manual Rev. 1.0
Downloaded from Elcodis.com electronic components distributor
Open the workspace and project in HEW.
Select [Renesas M16C Standard Toolchain] from Options pull-down menu.
Click on Link tab.
Select [Output] under the [Category] list box.
Click on checkbox for [-g] 'Outputs source debug information....'
Click on [OK] button
13 / 22
Applications Engineering
December 2003