Ethernet Connection; Hardwired Remote To Ctrl 1 - Barco XLM H25 Owner's Manual

3. Connections
RS232/422 Serial Network OUT
3 TXB-
Transmitted Data (TD or TX or TXD)
4TXB+ Data Terminal Ready (DTR)
5 GND Signal Ground (GND)
3.4.2

Ethernet connection

Connection
Connect port 1 or port 2 to a LAN by using a straight cable or a crossed cable. The connection is a 10/100 baseT.
Image 3-20
Ethernet connection
The projector must have an IP address and the IP address of the connected PC must be within the same range of IP addresses.
Once getting access, it is possible to check and manipulate all projector settings. Remote diagnostics, control and monitoring be-
come very simple.
The 2 ports are functionally identical. Both ports are connected via the projector hub.
Pin configuration
Ethernet 10/100 base T Port 1 & 2
1 TXD+
2 TXD-
3 RXD+
4 ++2.5VA
3.4.3

Hardwired remote to CTRL 1

How to connect
1. Plug one end of the remote cable in the connector on the bottom of the RCU. (image 3-21)
2. Plug the other end in the connector in the input panel of the projector labelled CTRL 1.
Specifications of the CTRL 1 input:
- U = 9V
in
- I = 80 mA
max
Internal IR receiver can be disabled:
mono jack : on plug in of the jack
o
stereo jack : on plug in or using an external switch bringing the right channel (B) to ground level. (image 3-22)
o
32
BI-DIRECTIONAL UNI-DIRECTIONAL
PUSH PUSH
2 1 2 1
3 3
CTRL 2 CTRL 1 PORT 1 PORT 2
CTRL 3
HARDWIRED REMOTE 10/100 BASE T
-
8
-
9
- -
WIRELESS REMOTE
RS232/422 IN MONITOR OUT
RS232/422 OUT MONITOR OUT
SERIAL NETWORK
5 ++2.5VA
6 RXD-
7 RXD-
8 GNDM
R5976690 XLM H25 03/09/2004