Table of Contents
Advertisement
User Manual NMEA 2000 / EtherNet/IP - Converter
Document code: MN67458_ENG
Revision 1.000
Page 11 of 31
Industrial Electronic Devices
ETHERNET:
The connection of EtherNet/IP in the HD67458 device must be made with at least a Category 5E cable. The maximum length of the cable
should not exceed 100m. The cable has to conform to the T568 norms relative to connections in cat.5 up to 100 Mbps. To connect the device
to an Hub/Switch is recommended the use of a straight cable, to connect the device to a PC/PLC/other is recommended the use of a cross
cable.
The connection of EtherNet/IP in the HD67458-E4x-xx device must be made with RJ45
connector.
The connection of the EtherNet/IP in the HD67458-E7x-xx device must be made with a AMP
SuperSeal 1.5 Male connector. The pinout of Female connector of the board is at right side of the
page.
USB:
The USB port is used to start the converter in Boot Mode. It is necessary to use a Micro USB type B cable.
ADFweb.com Srl – IT31010 – Mareno – Treviso
INFO:
www.adfweb.com
Phone +39.0438.30.91.31
Advertisement
Table of Contents
Need help?
Do you have a question about the HD67458 and is the answer not in the manual?
Questions and answers