Table of Contents
Advertisement
Cleaning
Protect the environment and use biodegradable cleaning agents to clean the surfaces. Clean
the surfaces of the charging station with a damp cloth.
Do not use a steam or water jet for cleaning, because moisture or water may penetrate into
the charging station. Moisture inside the charging station poses a risk of electric shock.
Failure to follow these instructions may result in hazardous situations that could cause death
or serious injury.
2.2
Safe installation and assembly
To avoid hazards, only qualified personnel may place and install the charging station. The
charging station must be disconnected from the mains. Follow the installation and assembly
instructions provided. Observe the applicable regional standards and regulations. Failure to
follow safety instructions may result in hazardous situations that could cause death or serious
injury.
Safety at the work site
When working on roads, construction sites and in public areas, ensure safety in line with local
requirements and regulations.
To perform the work properly, you need to observe:
• Legal specifications
• On-site safety requirements
• Road traffic conditions
Note the following:
• Secure the working area in accordance with the "Guidelines for the safety of workstations
on roads" or similar regional regulations.
• Use appropriate cordoning equipment if needed.
• Always wear a safety vest when working in the area of road traffic.
• Provide for adequate space in the working area. The working area should be at least 8
meters in diameter.
• Comply with the valid building regulations for parking spaces for electric cars including
charging stations.
Risk of accident in limited workspace
In order to avoid collisions and crushing, always ensure sufficient clearance to surrounding
obstacles when setting up the charging station.
There must be no objects on the ground in the working area to rule out the risk of tripping.
SICHARGE Operating instructions, ERK
Operating Instructions, 06/2021, A5E48571690-AC
Safety instructions
2.2 Safe installation and assembly
11
Advertisement
Table of Contents
