Installing The Switch In A 19-Inch Rack; Installation Methods - H3C S5560S-EI Series Installation Manual

Installing the switch in a 19-inch rack

Installation methods

Table 2-2 Installation methods for the S5560S-EI and the S5130S-HI switches
Chassis
S5560S-28F-EI
S5560S-52F-EI
S5560S-28P-EI
S5560S-52P-EI
S5560S-28S-EI
S5560S-52S-EI
S5130S-28S-HI
S5130S-52S-HI
S5130S-28C-HI
S5130S-52C-HI
S5560S-28S-PWR-
EI
S5560S-52S-PWR-
EI
S5130S-28S-PWR-
HI
S5130S-28S-UPW
R-HI
S5130S-52S-PWR-
HI
S5130S-28C-PWR-
HI
S5130S-52C-PWR-
HI
Figure 2-2 Procedure for rack-mounting the switch by using the front mounting brackets
Select an installation
position for the
mounting brackets
(near the port side or
power supply side)
Figure 2-3 Procedure for rack-mounting the switch by using the front and rear mounting
brackets
Select an installation
position for the front
mounting brackets
(near the port side or
power supply side)
Installation
Installation requirements
methods
Using front
Install the front mounting brackets at the
mounting
port side or the power supply side.
brackets
•
Install the front mounting brackets at
the port side or power supply side.
•
Install the rear mounting brackets
according to the rack depth.

Using front and

rear mounting
brackets
•
To use PSR1110-56A power supplies,
do not install the switch in a rack with a
depth of 600 mm (23.62 in)
Attach the mounting
brackets to the switch
Attach the front
mounting brackets to
screws to the switch
the switch
If the rack depth is in the range of
429 to 595 mm (16.89 to 23.43 in),
orient the bracket with the wide
flange inside the rack.
If the rack depth is in the range of
274 to 440 mm (10.79 to 17.32 in)
and the distance from the rear rack
posts to the inner surface of the
cabinet door is longer than 153 mm
(6.02 in), orient the bracket with the
wide flange outside the rack.
Mount the switch in
the rack
Attach the rear
Attach the shoulder
mounting brackets to
2-7
Installation
procedure
See
"Rack-mounting the
switch by using front
mounting
See
"Rack-mounting the
switch by using front
and rear mounting
brackets."
Mount the switch in
the rack
the rack
brackets."