Sfp+ Port - H3C S5560S-EI Series Installation Manual

GE SFP
transceiver
module and
cable
SFP-GE-LH70-
SM1550-BIDI
SFP cable
SFP-STACK-Kit
IMPORTANT:
The SFP-GE-LX-SM1310-BIDI and SFP-GE-LX-SM1490-BIDI transceiver modules, the
SFP-GE-LH40-SM1310-BIDI and SFP-GE-LH40-SM1550-BIDI transceiver modules, and the
SFP-GE-LH70-SM1490-BIDI and SFP-GE-LH70-SM1550-BIDI transceiver modules must be used
in pairs. For example, if one end uses an SFP-GE-LX-SM1310-BIDI transceiver module, the other
end must use an SFP-GE-LX-SM1490-BIDI transceiver module.
NOTE:
• As a best practice, use only H3C SFP transceiver modules and cables for the SFP ports.
• The H3C SFP transceiver modules and cables available for the SFP ports are subject to change
over time. For the most recent list of SFP transceiver modules and cables available for the SFP
port, contact your H3C Support or marketing staff.
• For the specifications of H3C SFP transceiver modules and cables, see H3C Transceiver
Modules User Guide.

SFP+ port

The following switches each provide four fixed SFP+ ports on the front panel:
•
S5560S-28F-EI
•
S5560S-52F-EI
•
S5560S-28S-EI
•
S5560S-52S-EI
•
S5560S-28S-PWR-EI
•
S5560S-52S-PWR-EI
•
S5130S-28C-HI
•
S5130S-28S-HI
•
S5130S-52S-HI
•
S5130S-28C-PWR-HI
•
S5130S-28S-PWR-HI
•
S5130S-28S-UPWR-HI
•
S5130S-52S-PWR-HI
The S5130S-52C-HI and S5130S-52C-PWR-HI switches each provide two fixed SFP+ ports on the
front panel.
To connect peer SFP+ ports over a long distance, use SFP/SFP+ transceiver modules and fibers. To
connect peer SFP+ ports over a short distance, use SFP+ cables. You can install the GE SFP
transceiver module in Table4-5, 10-GE SFP+ transceiver modules in Table4-6, and 10-GE SFP+
cables in Table4-7
Central
wavelength Connector
(nm)
TX: 1550 nm
LC
RX: 149 nm
N/A
in the SFP+ ports.
Cable/Fiber
type and
diameter (µm)
Single-mode,
9/125
4-38
Modal Max
bandwidth transmission
(MHz × km) distance
70 km (43.49
N/A
miles)
1.5 m (4.92 ft)