Removing A Psr180-56A/Psr360-56A/Psr560-56D/Psr720-56A/Psr1110-56A Power Supply - H3C S5560S-EI Series Installation Manual

Figure 2-24 Installing the power supply
Figure 2-25 PSR1110-56A power supply installed in the chassis
NOTE:
The PSR1110-56A power supply, including its handle, adds 64 mm (2.52 in) to chassis depth.
Removing a
PSR180-56A/PSR360-56A/PSR560-56D/PSR720-56A/PSR
1110-56A power supply
The removal procedure is the same for the PSR180-56A, PSR360-56A, PSR560-56D, PSR720-56A,
and PSR1110-56A power supplies. The following procedure uses the PSR720-56A power supply as
an example.
To remove a PSR720-56A power supply:
1. Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2. Disconnect the power cord.
3. Press the latch towards the handle, and pull the power supply along the guide rails until it is
part-way out.
4. Grasp the handle of the power supply with one hand, support the bottom with the other hand,
and pull the power supply slowly along the guide rails out of the slot.
Keep the removed power supply in an antistatic bag or the power supply package bag for future
use.
2-21