Equipment Set-Up And Close Procedures - Taylor C850 Series Equipment Manual

Equipment Set-Up and Close
Procedures
The two platen Model C852 has been selected to
illustrate the step-by-step procedures in this manual. For
grills equipped with less than two platens, perform the
following steps as appropriate for your grill platen
configuration.
Installing Upper Platen Release Sheets
1. Carefully wrap the release sheet side flaps over the
side cover rails. Secure the sheet with the locking
clips. The back edge of the sheet will not be
secured, but instead will hang free. See Figure 11.
Figure 11
1. Center the release sheet on the front of the upper
platen. Pull it tightly over the release material
cover rail located in the front of the platen and
secure it with a locking clip. See Figure 12.
Figure 12
IMPORTANT! Do not crease the release sheet.
This will greatly reduce the life of the sheet.
2. Make sure the release sheets are tight across the
upper platen surface.
3. Repeat these steps for the other upper platen on
the Models C852 and C856.
The release sheet must be changed when:
S
Product sticks to the release sheet.
S
Carbon builds up, causing problems in taste or
appearance.
S
There is a tear in the release sheet in the
cooking area.
S
The release material substance is worn from
the release sheet.
Note: Reverse the cooking side of the release sheets on
a daily basis. (example: black side on odd days; grey or
brown side on even days)
Care of Release Sheets
S
DO NOT fold or crease.
S
DO NOT touch with any sharp object or
abrasive.
S
DO NOT hose with hot water or soak in water.
S
DO NOT place under other objects.
Start-Up Grill
IMPORTANT: The lower grill plate and the upper
platen MUST BE CLEAN before starting these
procedures.
Note: Grills that use lower release sheets require start
up of grill before installation of lower release sheets.
1. Place the fan interlock switch in the ON position.
The controller will initialize and then display the
following screen. See Figure 13.
22
Figure 13