Operating Procedures; Morning Procedures - Taylor C801 Operating Instructions Manual

Section 6
Approximately half of each grill is dedicated to
cooking and the other half is used for staging cooked
meat.
Each model has a lower cook surface. Excluding the
P802, each model also has two or more upper
platens. The two-sided cooking concept ensures
quick, even cooking of both sides of the products
placed on the lower surface. The upper platens are
labeled to indicate which patty size can be cooked
under that platen (2 oz. or 4 oz.).
One or more of the upper platens is adjustable. This
adjustable platen can be adjusted to cook either 2
oz. or 4 oz. patties.
If an adjustable platen is chosen, rotate the lever up
for 4 oz. patties and down for 2 oz. patties. The lever
is attached to an over-center device to ensure a
positive selection of the proper gap.
Sensors detect the lever position They indicate "2
oz." or "4 oz." on the display and make all
appropriate timing adjustments.
Figure 22
A minimum of one patty and a maximum of eight 4
oz. or ten 2 oz. patties may be cooked under one
grill platen.
We begin our instructions with the Morning
Procedures.
Note: The Model C801 has been selected to
illustrate the step-by-step operating procedures.

Operating Procedures

Operating Procedures

Morning Procedures

The top platens and release sheets are cleaned
during the Morning Procedures.
Assemble the following tools:
S
Blue scrub
S
DCT Heavy Duty Degreaser
S
Dry white towel
S
1/6-sized, 4-inch deep pan of water
S
Vinyl gloves
CAUTION: The grill must remain in the
OFF position for cleaning. (The grill should be
cool.) Failure to follow this instruction may result in
severe burns from high temperatures.
Removing Platen Release Sheets
Step 1
The upper platen must be in the UP position in order
to remove the platen release sheet.
Step 2
Pull the retainer clip off of the release sheet bracket
located on the front of the platen. The release sheet
will drop loose.
Step 3
Remove the release sheet bracket from the front of
the platen. Set it aside on the staging side of the
grill.
Step 4
Lift the rear release sheet bracket assembly off the
rear of the platen. The release sheet and the bracket
assembly will come off of the platen together.
Step 5
Remove the retainer clip and the release sheet
bracket from the release sheet and set them aside
on the staging side of the grill.
Step 6
Lay the release sheet flat on the staging side of the
grill.
26
C801/C801R/F802/P802/C803/C803R/C804