Taylor C850 Series Equipment Manual page 4

of the frame by the authorized installer. The installation
location is marked by the equipotential bonding symbol
(5021 of IEC 60417­1) on both the removable panel and
the equipment's frame.
S
DO NOT operate the unit unless it is properly
grounded.
S
DO NOT operate the unit with larger fuses
than specified on the data label.
S
All repairs must be performed by an authorized
Taylor service technician.
S
The main power supplies to the machine must
be disconnected prior to performing any
repairs.
S
For Cord Connected Units: Only Taylor
authorized service technicians or licensed
electricians may install a plug or replacement
cord on these units.
S
Stationary appliances which are not equipped
with a power cord and a plug or other device to
disconnect the appliance from the power
source must have an all-pole disconnecting
device with a contact gap of at least 3 mm
installed in the external installation.
S
Appliances that are permanently connected to
fixed wiring and for which leakage currents
may exceed 10 mA, particularly when
disconnected or not used for long periods, or
during initial installation, shall have protective
devices such as a GFI, to protect against the
leakage of current, installed by the authorized
personnel to the local codes.
S
Supply cords used with this unit shall be
oil­resistant, sheathed flexible cable not lighter
than ordinary polychloroprene or other
equivalent synthetic elastomer­sheathed cord
(Code designation 60245 IEC 57) installed
with the proper cord anchorage to relieve
conductors from strain, including twisting, at
the terminals and protect the insulation of the
conductors from abrasion.
If the supply cord is damaged, it must be
replaced by an authorized Taylor service
technician in order to avoid a hazard.
Failure to follow these instructions may result in
personal injury, equipment damage, or poor grill
performance.
S
This appliance must be isolated from all
combustible construction and materials
including, but not limited to; walls, partitions,
furniture, floors, curtains, paper, boxes, and
decorations. Failure to comply may result in
fire and cause destruction and severe injury.
Do not store or use gasoline or other flam­
mable vapors or liquids in the vicinity of this
or any other appliance.
S
DO NOT obstruct the ventilation openings at
the rear of this appliance.
S
DO NOT obstruct the flow of air in and around
the grill.
S
DO NOT operate the grill unless all service
panels and access doors are attached with
screws. Failure to comply may result in
personal injury from gas or electrical
components.
USE EXTREME CAUTION while setting up,
operating, and cleaning the grill. Avoid coming in
contact with the hot grill surfaces or with the hot grease.
Failure to comply will result in burn injuries.
S
The grill must be placed on a level surface.
S
To ensure thorough cleaning, the grill must be
pulled away from the wall. When returning the
grill to its original position, use extreme
caution to smoothly and slowly roll the grill
backward into place and lock the front casters.
Failure to follow these instructions may cause the grill
to tip and can result in severe equipment damage or
personal injury.
NOTICE all warning labels that have been
attached to the grill to further point out safety
precautions to the operator.
2
WARNING