Handlebar Angle Adjustment; Handlebar Riser Angle Adjustment - Polaris 850 MATRYX INDY XC 129 2021 Manual

STEERING / SUSPENSIONS

HANDLEBAR ANGLE ADJUSTMENT

Handlebar angle can be adjusted to suit rider preference.
The factory-desired setup angles are shown below.
1. Loosen the four fasteners on the top riser block.
2. Adjust the handlebar upward or downward to the
desired angle. Be sure the handlebar, brake lever and
throttle lever operate smoothly and do not hit the gas
tank, windshield or any other part of the machine
when turned fully to the left or right. If necessary,
loosen the set screws for the left and right controls,
rotate the controls slightly, then tighten the set screws
to the proper torque.
MEASUREMENT
Short Riser (60 mm):
26.5° ± 3°
Tall Riser (85 mm):
31.5° ± 3°
IMPORTANT
Do not stretch wires while adjusting the controls.
Stretching the wires could damage the handwarmers.
3. Tighten the fasteners to specification.
TORQUE
Handlebar Riser Fasteners:
11 ft-lbs (15 N·m)
8.50

HANDLEBAR RISER ANGLE ADJUSTMENT

Riser angle can be adjusted to suit rider preference. The
factory-desired setup angles are shown below.
1. Loosen the four fasteners on the bottom of the
adjuster block. If necessary, pry the blocks apart with
a screwdriver.
2. Adjust the riser forward or rearward to the desired
position. Factory settings are shown below.
3. Tighten the front riser block fasteners first and then
the rear bolts, tightening both equally.
4. Tighten the fasteners to specification.
9850064 R03 - 2021 650 / 850 Matryx Trail Performance / Crossover Snowmobile Service Manual
MEASUREMENT
Short Riser (60 mm) / Tall Riser (85 mm):
11° ± 3°
TORQUE
Handlebar Riser Fasteners:
11 ft-lbs (15 N·m)
© Copyright Polaris Inc.