Handlebar Adjustments; Handlebar Angle - Polaris 600 Indy Owner's Manual

THE PERFECT FIT

Handlebar Adjustments

Handlebar Position (if equipped)
1. Loosen the four bolts on the
bottom of the adjuster block. If
necessary, pry the blocks apart
with a screwdriver.
2. Adjust the handlebar forward or
rearward to the desired posi-
tion.
3. Tighten the bolts.

Handlebar Angle

1. Loosen the four bolts on the top
of the adjuster block. If neces-
sary, pry the blocks apart with a
screwdriver.
2. Adjust the handlebar forward or
rearward to the desired angle.
Be sure handlebars, brake lever
and throttle lever operate
smoothly and do not hit the gas
tank, windshield or any other
part of the machine when
turned fully to the left or right.
If necessary, loosen the set screws for the left and right controls,
rotate the controls slightly, then tighten the set screws to the proper
torque.
NOTICE: Do not stretch wires while adjusting the controls. Stretching the wires
could damage the handwarmers.
• Right control torque: 27 in. lbs. (3.05 Nm) +/- 10%.
• Left control torque: 24 in. lbs. (2.7 Nm) +/- 10%.
3. Tighten the bolts.
54
Loosen top bolts to adjust
handlebar angle
Loosen bottom bolts to
adjust handlebar position
(if equipped)