Hood Removal; Hood Installation - Polaris 850 MATRYX INDY XC 129 2021 Manual

HOOD REMOVAL

IMPORTANT
The hood and side panels protect the operator from
moving parts. Never operate a snowmobile with the
side panels open or removed. Always ensure that the
hood and side panels are installed and securely latched
before starting the engine unless instructed to do so for
servicing reasons.
1. Remove the left and right side panels.
2. Rotate the 1/4 turn fasteners
the hood.
3. Pull hood over 1/4 turn mounts before lifting on hood.
4. Disconnect the hood wire harness connector
5. Remove the hood assembly from the vehicle.
9850064 R03 - 2021 650 / 850 Matryx Trail Performance / Crossover Snowmobile Service Manual
© Copyright Polaris Inc.

HOOD INSTALLATION

1. Install the hood
q
at the rear corners of
2. Lay the hood down onto the overstructure.
3. Reconnect the hood wire harness connector.
4. Secure rear of the hood to the console with the 1/4
5. Reinstall the left and right side panels.
w
.
q
by inserting the front of the hood
into the nosepan.
NOTICE
Verify the harness connectors are clean and dry prior to
assembly.
turn fasteners.
MAINTENANCE
2
2.19