Polaris 850 MATRYX INDY XC 129 2021 Manual page 522

STEERING / SUSPENSIONS
REAR SUSPENSION
FRONT TRACK SHOCK FACTORY SPRING
SETTINGS
IMPORTANT
When making spring setting adjustments, always
remove the weight of the snowmobile from the spring
being adjusted. Always verify the spring collars /
retainers are tight and holding the spring(s) in position.
NOTICE
Never adjust spring preload to an installed length longer
than the factory length or shorter than the minimum
length as shown in the following chart. Damage to the
suspension could result. When decreasing preload,
make sure at least two turns of preload are holding the
retainer against the spring.
MAXIMUM
FACTORY
INSTALLED
SPRING
LENGTH
1.62 in (4.1 cm)
INDY XC
2.25 in (5.7 cm)
INDY VR1
NOTICE
Spring preload is measured between edge of shock
body cap and spring edge - not shock locking collar /
retainers.
8.68
FRONT TRACK SHOCK FACTORY CLICKER
SETTINGS
REAR TRACK SHOCK FACTORY CLICKER
SETTINGS
MINIMUM
INSTALLED
LENGTH
1.38 in (3.5 cm)
1.75 in (4.5 cm)
9850064 R03 - 2021 650 / 850 Matryx Trail Performance / Crossover Snowmobile Service Manual
CLICKER SETTING
MODEL
(FROM FULL HARD)
INDY XC
INDY VR1
CLICKER SETTING
MODEL
(FROM FULL HARD)
INDY XC
INDY VR1
5
5
5
6
© Copyright Polaris Inc.