Shocks - Igx 146 Models; Front Track Shock (Fts) Service - Polaris 850 MATRYX INDY XC 129 2021 Manual

STEERING / SUSPENSIONS

SHOCKS - IGX 146 MODELS

FRONT TRACK SHOCK (FTS) SERVICE

FRONT TRACK SHOCK (FTS) REMOVAL
1. With the snowmobile sitting on a flat surface, note the
where the limiter strap screw is installed. Remove the
fastener securing the top of the limiter strap to the
front torque arm cross shaft.
NOTICE
Limiter strap fastener shown in the stock (upper hole)
position.
2. Raise the rear of the snowmobile off of the ground
using a dedicated track stand or similar device.
3. To access the FTS lower cross shaft rail beam
screws, remove the left and right bogie wheels. Note
the orientation of the screws, washers, and nuts.
8.40
4. Measure the shock preload setting. Loosen the spring
preload by turning the preload adjuster clockwise.
5. Remove the fastener securing the shock rod to the
front torque arm. Discard the lock nut.
6. Remove the two screws securing the FTS cross shaft
to the left and right rail beams. Note there is a washer
on each screw.
9850064 R03 - 2021 650 / 850 Matryx Trail Performance / Crossover Snowmobile Service Manual
© Copyright Polaris Inc.