CONTROL ARM SERVICE
LOWER CONTROL ARM REMOVAL
1. Remove the spindle and ski as an assembly.
2. Remove the sway bar link fastener
e
3. Remove the fastener
and nut
shock to the lower control arm. Discard the flange
nut.
t
4. Remove the flange nuts
y
flange nut
. Discard the flange nuts. Remove the
lower control arm assembly
9850064 R03 - 2021 650 / 850 Matryx Trail Performance / Crossover Snowmobile Service Manual
© Copyright Polaris Inc.
q
w
and nut
.
r
securing the
and front pivot screw /
u
.
STEERING / SUSPENSIONS
LOWER CONTROL ARM INSTALLATION
1. Reinstall the control arm assembly
arm pivot onto the bulkhead studs using new flange
t
nuts
. Torque flange nuts to specification.
NOTICE
The lower control arm front pivot is secured with a
y
screw
and flange nut. Install this screw from the right
side of the vehicle.
TORQUE
Control Arm Pivot Stud Flange Nuts:
30 ft-lbs (41 N·m)
Front Lower Control Arm Pivot Screw / Nut:
40 ft-lbs (54 N·m)
e
2. Install the shock fastener
Torque nut to specification.
TORQUE
Shock Mounting Fasteners:
37 ft-lbs (50 N·m)
u
. Secure control
8
r
and new flange nut
.
8.23